EMC Control Panel & CE Marking Certified Control Panel

For control panels, we select PLCs, relays and other materials for your needs, providing wiring diagrams and ladder lists, performing integrated test using simulator. Also, we are producing air-signal control panels which are still used in many plants.

For the panel to be located at the site, the surrounding environment of the installation location is very important. Various conditions have to be considered such as; if the site is in a potentially dangerous environment, is the site indoors or outdoors, it is in proximity to any corrosive gas or dust, there are any fluctuations in temperature, there is the possibility of the entry of any small animals, windy conditions can cause objects to fly around etc. HINO SYSTECH searches for the location that satisfies the above conditions and provides the panels complying with NEC, NEMA or NFPA standards, etc.

HINO SYSTECH manufactures the distribution panels in compliance with JIS, JEC, JEM or JEC IP-42 or 52 standards and therefore along with the path ducts from the high-pressure load center to low-pressure load center and motor control center, are both reliable and safe.

Extra-high voltage substation equipment for distributed mega solar power plants. Proven ring main unit, power distribution panel and transformer are installed in one unit. They have excellent cost advantage by simplifying electrical wiring work and test at site.

EMC ( Electro-Magnetic Compatibility ) means that the electric equipment has an electromagnetic non-interference or resistance ability. Until recently, the treatment for EMC for the existing equipment was more of an estimate based on past knowledge and experience rather than a precise measurement. However, this will become outdated as designed frequency become higher and the demand for accuracy is greater. In accordance with EMC standards, HINO SYSTECH designs and manufacturers high quality control panels where electromagnetic properties are taken into account. HINO SYSTECH also performs testing along with preparing all documents required to obtain the certification. The CE mark is attached to all products that comply with standards from all the EC countries. This certification must be obtained before selling products in EU countries. HINO SYSTECH was quick in its efforts to obtain the CE Marking Certification and so far have delivered a lot of CE marked control panels to European countries.

HINO SYSTECH manufactures the standard control panels complying with the following standards. JIS ( Japanese Industrial Standards ) IEC ( International Electrotechnical Commission ) UL ( Underwriters Laboratories Inc. ) NEMA ( National Electrical Manufacturings Association ) NFPA ( National Fire Protection Association ) CSA ( Canadian Standards Association )

The original conception for the GOST STANDARD was started in former Soviet Union in 1925 after WWII, for the purpose of maintaining high quality products. In the end of 1991, when the Soviet Union broke apart, GOST became administered by the EASC. After the GOST standard became recognized by the ISO ( International Standard Organization ), regional standards were implemented from various countries. It now currently resembles EN or CN standards and serves as the basis for certification in most of the CIS countries. The national standards for Russia are now referred to as GOST-R and in a similar way, the Kazakhstan GOST STANDARD is called GOST-K and Uzbekistan GOST STANDARD is called GOST-U. HINO SYSTECH manufactures the control panels complying with GOST STANDARD.